X10 TW523 & All Housecode RF Transceiver (1135K)
Never Used!
Transmit Signals Through Power Lines to Your X10 Devices Receives all 256 house/unit code addresses X10 signals transmitted through powerlines 150-foot range
Skip the time-consuming process of setting house codes on your RF receiver with the All Housecode RF Transceiver, which comes preset with all house codes and unit codes enabled, so no setting of the house code dials is required. The transceiver receives all 256 house code/unit code addresses plus commands (On, Off, Bright, Dim, All Lights On, All Units Off, etc.), then filters these signals according to your setup. This information is then presented to the included X10 TW523, a powerline interface unit that transmits your X10 commands over your household wiring to any X10 device capable of receiving them.
Setting up the All Housecode RF Transceiver is easy. Should you desire to filter or selectively inhibit specific house codes/unit codes, you will need a PC with Windows 98 or later as your OS, a serial port and the supplied RS232 cable.
| Connect the All Housecode RF Transceiver to your PC to assign the X10 address and program unit code filtering. Once the X10 address and zone cycle durations have been set, the All Housecode RF Transceiver can be disconnected from the PC and will respond to X10 signals just like any other X10-connected device. The All Housecode RF Transceiver does not have to be connected to a PC for everyday operation. |
| Packaged with an external whip antenna, the All Housecode RF Transceiver will pick up signals from any X10 RF transmitter within its 150-foot range and is equipped with the ability to filter specific house and unit codes, since its vast range may pick up a neighbor's X10 remote. It's even safe for outdoor use if mounted in a weatherproof enclosure. |
Weight: 1.00 Pound(s) |
