Leviton 15A Relay X10 Wall Switch w/AGC (6291-WI)
Never Used!
Automated Wall Switch Control for Fluorescent Lights & Appliances
For high-wattage lighting (without dimming) Use for anything rated up to 15 amps! Control ceiling fans without hearing hum from the motor
For automated control of fluorescent lights, appliances or high wattage incandescent lighting, simply replace your existing wall switches with these easy-to-install, X10-compatible, 15 Amp Leviton Wall Switches. Unlike standard dimmer switches, which use triacs for switching, these Leviton wall switches use a mechanical relay to switch the load, so they have a much higher load capacity. For ceiling fans, since the electricity is not being modified by the triac in a dimmer, the electricity going to the fan motor is a pure sine-wave and won't cause the fan's motor to make an audible hum.
These Leviton Wall Switch Modules come with an interchangeable white/ivory paddle switch cover. Trim plate is not included. These Leviton Wall Switches require a neutral wire connection.
NOTE: Because this switch responds to the ALL LIGHTS ON command, care should be taken when used to switch non-lamp loads. If you don't want your appliance to respond to this command, use an X10 Appliance Module or an X10 Wall Receptacle.
The relay switching and 3-wire connection means the X10 receiver circuitry is somewhat isolated from the load and is relatively unaffected by the type of load being switched (provided it does not exceed rated capacity). Features of these 15 Amp Leviton Wall Switches include ALL LIGHTS ON and ALL UNITS OFF command response and a red LED light that indicates the switch is on.
Weight: 2.50 Pound(s) |
